qlge: Fix EEH handling.

Clean up driver resources without touch the hardware. Add pci
save/restore state.

Signed-off-by: Ron Mercer <ron.mercer@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Ron Mercer 2009-10-28 08:39:20 +00:00 committed by David S. Miller
parent 55888dfb6b
commit 6d190c6edf

View File

@ -3916,6 +3916,7 @@ static int __devinit ql_init_device(struct pci_dev *pdev,
goto err_out;
}
pci_save_state(pdev);
qdev->reg_base =
ioremap_nocache(pci_resource_start(pdev, 1),
pci_resource_len(pdev, 1));
@ -4070,6 +4071,33 @@ static void __devexit qlge_remove(struct pci_dev *pdev)
free_netdev(ndev);
}
/* Clean up resources without touching hardware. */
static void ql_eeh_close(struct net_device *ndev)
{
int i;
struct ql_adapter *qdev = netdev_priv(ndev);
if (netif_carrier_ok(ndev)) {
netif_carrier_off(ndev);
netif_stop_queue(ndev);
}
if (test_bit(QL_ADAPTER_UP, &qdev->flags))
cancel_delayed_work_sync(&qdev->asic_reset_work);
cancel_delayed_work_sync(&qdev->mpi_reset_work);
cancel_delayed_work_sync(&qdev->mpi_work);
cancel_delayed_work_sync(&qdev->mpi_idc_work);
cancel_delayed_work_sync(&qdev->mpi_port_cfg_work);
for (i = 0; i < qdev->rss_ring_count; i++)
netif_napi_del(&qdev->rx_ring[i].napi);
clear_bit(QL_ADAPTER_UP, &qdev->flags);
ql_tx_ring_clean(qdev);
ql_free_rx_buffers(qdev);
ql_release_adapter_resources(qdev);
}
/*
* This callback is called by the PCI subsystem whenever
* a PCI bus error is detected.
@ -4078,17 +4106,21 @@ static pci_ers_result_t qlge_io_error_detected(struct pci_dev *pdev,
enum pci_channel_state state)
{
struct net_device *ndev = pci_get_drvdata(pdev);
struct ql_adapter *qdev = netdev_priv(ndev);
netif_device_detach(ndev);
if (state == pci_channel_io_perm_failure)
switch (state) {
case pci_channel_io_normal:
return PCI_ERS_RESULT_CAN_RECOVER;
case pci_channel_io_frozen:
netif_device_detach(ndev);
if (netif_running(ndev))
ql_eeh_close(ndev);
pci_disable_device(pdev);
return PCI_ERS_RESULT_NEED_RESET;
case pci_channel_io_perm_failure:
dev_err(&pdev->dev,
"%s: pci_channel_io_perm_failure.\n", __func__);
return PCI_ERS_RESULT_DISCONNECT;
if (netif_running(ndev))
ql_adapter_down(qdev);
pci_disable_device(pdev);
}
/* Request a slot reset. */
return PCI_ERS_RESULT_NEED_RESET;
@ -4105,25 +4137,15 @@ static pci_ers_result_t qlge_io_slot_reset(struct pci_dev *pdev)
struct net_device *ndev = pci_get_drvdata(pdev);
struct ql_adapter *qdev = netdev_priv(ndev);
pdev->error_state = pci_channel_io_normal;
pci_restore_state(pdev);
if (pci_enable_device(pdev)) {
QPRINTK(qdev, IFUP, ERR,
"Cannot re-enable PCI device after reset.\n");
return PCI_ERS_RESULT_DISCONNECT;
}
pci_set_master(pdev);
netif_carrier_off(ndev);
ql_adapter_reset(qdev);
/* Make sure the EEPROM is good */
memcpy(ndev->perm_addr, ndev->dev_addr, ndev->addr_len);
if (!is_valid_ether_addr(ndev->perm_addr)) {
QPRINTK(qdev, IFUP, ERR, "After reset, invalid MAC address.\n");
return PCI_ERS_RESULT_DISCONNECT;
}
return PCI_ERS_RESULT_RECOVERED;
}
@ -4131,17 +4153,21 @@ static void qlge_io_resume(struct pci_dev *pdev)
{
struct net_device *ndev = pci_get_drvdata(pdev);
struct ql_adapter *qdev = netdev_priv(ndev);
int err = 0;
pci_set_master(pdev);
if (ql_adapter_reset(qdev))
QPRINTK(qdev, DRV, ERR, "reset FAILED!\n");
if (netif_running(ndev)) {
if (ql_adapter_up(qdev)) {
err = qlge_open(ndev);
if (err) {
QPRINTK(qdev, IFUP, ERR,
"Device initialization failed after reset.\n");
return;
}
} else {
QPRINTK(qdev, IFUP, ERR,
"Device was not running prior to EEH.\n");
}
netif_device_attach(ndev);
}