forked from luck/tmp_suning_uos_patched
e1000e: fix flow control denial of service possibility
this patch avoids a denial of service from an evildoer sending a continuous stream of flow control at our adapter that is plugged into a non-flow control enabled switch. Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com> Signed-off-by: Jeff Garzik <jeff@garzik.org>
This commit is contained in:
parent
4a5694e664
commit
de92d84ec2
@ -1104,34 +1104,13 @@ s32 e1000e_config_fc_after_link_up(struct e1000_hw *hw)
|
||||
(mii_nway_lp_ability_reg & NWAY_LPAR_ASM_DIR)) {
|
||||
mac->fc = e1000_fc_rx_pause;
|
||||
hw_dbg(hw, "Flow Control = RX PAUSE frames only.\r\n");
|
||||
}
|
||||
/* Per the IEEE spec, at this point flow control should be
|
||||
* disabled. However, we want to consider that we could
|
||||
* be connected to a legacy switch that doesn't advertise
|
||||
* desired flow control, but can be forced on the link
|
||||
* partner. So if we advertised no flow control, that is
|
||||
* what we will resolve to. If we advertised some kind of
|
||||
* receive capability (Rx Pause Only or Full Flow Control)
|
||||
* and the link partner advertised none, we will configure
|
||||
* ourselves to enable Rx Flow Control only. We can do
|
||||
* this safely for two reasons: If the link partner really
|
||||
* didn't want flow control enabled, and we enable Rx, no
|
||||
* harm done since we won't be receiving any PAUSE frames
|
||||
* anyway. If the intent on the link partner was to have
|
||||
* flow control enabled, then by us enabling RX only, we
|
||||
* can at least receive pause frames and process them.
|
||||
* This is a good idea because in most cases, since we are
|
||||
* predominantly a server NIC, more times than not we will
|
||||
* be asked to delay transmission of packets than asking
|
||||
* our link partner to pause transmission of frames.
|
||||
*/
|
||||
else if ((mac->original_fc == e1000_fc_none) ||
|
||||
(mac->original_fc == e1000_fc_tx_pause)) {
|
||||
} else {
|
||||
/*
|
||||
* Per the IEEE spec, at this point flow control
|
||||
* should be disabled.
|
||||
*/
|
||||
mac->fc = e1000_fc_none;
|
||||
hw_dbg(hw, "Flow Control = NONE.\r\n");
|
||||
} else {
|
||||
mac->fc = e1000_fc_rx_pause;
|
||||
hw_dbg(hw, "Flow Control = RX PAUSE frames only.\r\n");
|
||||
}
|
||||
|
||||
/* Now we need to do one last check... If we auto-
|
||||
|
Loading…
Reference in New Issue
Block a user