kernel_optimize_test/drivers/net/wimax/i2400m
Inaky Perez-Gonzalez 1af7ad5104 wimax: fix build issue when debugfs is disabled
As reported by Toralf Förster and Randy Dunlap.

- http://linuxwimax.org/pipermail/wimax/2009-January/000460.html

- http://lkml.org/lkml/2009/1/29/279

The definitions needed for the wimax stack and i2400m driver debug
infrastructure was, by mistake, compiled depending on CONFIG_DEBUG_FS
(by them being placed in the debugfs.c files); thus the build broke in
2.6.29-rc3 when debugging was enabled (CONFIG_WIMAX_DEBUG) and
DEBUG_FS was disabled.

These definitions are always needed if debug is enabled at compile
time (independently of DEBUG_FS being or not enabled), so moving them
to a file that is always compiled fixes the issue.

Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
2009-01-29 17:18:31 -08:00
..
control.c wimax/i2400m: error paths that need to free an skb should use kfree_skb() 2009-01-19 17:58:08 -08:00
debug-levels.h
debugfs.c wimax: fix build issue when debugfs is disabled 2009-01-29 17:18:31 -08:00
driver.c wimax: fix build issue when debugfs is disabled 2009-01-29 17:18:31 -08:00
fw.c i2400m: firmware loading and bootrom initialization 2009-01-07 10:00:19 -08:00
i2400m-sdio.h i2400m/SDIO: header for the SDIO subdriver 2009-01-07 10:00:22 -08:00
i2400m-usb.h i2400m/USB: header for the USB bus driver 2009-01-07 10:00:21 -08:00
i2400m.h
Kconfig i2400m: Makefile and Kconfig 2009-01-07 10:00:22 -08:00
Makefile i2400m: Makefile and Kconfig 2009-01-07 10:00:22 -08:00
netdev.c i2400m: linkage to the networking stack 2009-01-07 10:00:18 -08:00
op-rfkill.c i2400m: Generic probe/disconnect, reset and message passing 2009-01-07 10:00:18 -08:00
rx.c i2400m: RX and TX data/control paths 2009-01-07 10:00:19 -08:00
sdio-debug-levels.h i2400m/SDIO: header for the SDIO subdriver 2009-01-07 10:00:22 -08:00
sdio-fw.c i2400m/SDIO: firmware upload backend 2009-01-07 10:00:22 -08:00
sdio-rx.c i2400m/SDIO: TX and RX path backends 2009-01-07 10:00:22 -08:00
sdio-tx.c i2400m/SDIO: TX and RX path backends 2009-01-07 10:00:22 -08:00
sdio.c i2400m/SDIO: probe/disconnect, dev init/shutdown and reset backends 2009-01-07 10:00:22 -08:00
tx.c i2400m: RX and TX data/control paths 2009-01-07 10:00:19 -08:00
usb-debug-levels.h i2400m/USB: header for the USB bus driver 2009-01-07 10:00:21 -08:00
usb-fw.c i2400m/USB: firmware upload backend 2009-01-07 10:00:21 -08:00
usb-notif.c i2400m/USB: TX and RX path backends 2009-01-07 10:00:21 -08:00
usb-rx.c wimax/i2400m: error paths that need to free an skb should use kfree_skb() 2009-01-19 17:58:08 -08:00
usb-tx.c i2400m/USB: TX and RX path backends 2009-01-07 10:00:21 -08:00
usb.c i2400m/usb: wrap USB power saving in #ifdef CONFIG_PM 2009-01-08 11:08:25 -08:00