forked from luck/tmp_suning_uos_patched
39baf8a798
* atiixp: if DMA can't be used atiixp_config_drive_for_dma() should return 0, atiixp_dma_check() will tune the correct PIO mode anyway * jmicron: if DMA can't be used config_chipset_for_dma() should return 0, micron_config_drive_for_dma() will tune the correct PIO mode anyway config_jmicron_chipset_for_pio(drive, !speed) doesn't program device transfer mode for speed != 0 (only wastes some CPU cycles on ide_get_best_pio_mode() call) so remove it * triflex: if DMA can't be used triflex_config_drive_for_dma() should return 0, triflex_config_drive_xfer_rate() will tune correct PIO mode anyway Above changes also fix (theoretical) issue when ->speedproc fails to set device transfer mode (i.e. when ide_config_drive_speed() fails to program it) but one of DMA transfer modes is already enabled on the device by the BIOS. In such scenario ide_dma_enable() will incorrectly return true statement and ->ide_dma_check will try to enable DMA on the device. Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com> |
||
|---|---|---|
| .. | ||
| arm | ||
| cris | ||
| h8300 | ||
| legacy | ||
| mips | ||
| pci | ||
| ppc | ||
| ide-acpi.c | ||
| ide-cd.c | ||
| ide-cd.h | ||
| ide-disk.c | ||
| ide-dma.c | ||
| ide-floppy.c | ||
| ide-generic.c | ||
| ide-io.c | ||
| ide-iops.c | ||
| ide-lib.c | ||
| ide-pnp.c | ||
| ide-probe.c | ||
| ide-proc.c | ||
| ide-tape.c | ||
| ide-taskfile.c | ||
| ide-timing.h | ||
| ide.c | ||
| Kconfig | ||
| Makefile | ||
| setup-pci.c | ||