sound/pci/rme9652/hdspm.c: In function 'snd_hdspm_hw_params':
sound/pci/rme9652/hdspm.c:3681: warning: format '%08X' expects type 'unsigned int', but argument 4 has type 'unsigned char *'
sound/pci/rme9652/hdspm.c:3692: warning: format '%08X' expects type 'unsigned int', but argument 4 has type 'unsigned char *'
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add a proper model (3stack) for ASUS M2N-MX with AD1986A codec.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Load the ASSP codes using request_firmware(), if possible, instead of
using the built-in blobs.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Load the DSP code using request_firmware(), if possible, instead of
using the built-in blob.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Adds support for digital microphone pin widgets on SigmaTel codecs.
Enables support only on the 9205 codecs for now.
Signed-off-by: Matt Porter <mporter@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add a proper model entry (3stack) for Lenovo A60 desktop with
AD1986a codec to fix noise problems.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Don't enable power-saving mode on drivers that don't support
it. The supporting drivers set AC97_SCAP_POWER_SAVE to scaps
at creation of ac97 instance.
Currently enable on the following drivers: intel8x0, intel8x0m,
atiixp, atiixp-modem, via82xx and via82xx-modem.
Also, a bit clean up of power-saving stuff:
- Don't create an own workq
- Remove superfluous ifdefs
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch adds support for Asus laptops (for example: Asus
A6Rp-AP002).
Signed-off-by: Mariusz Domanski <mariook@wp.pl>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add DDS register support for RME9632 rev >= 152.
This register sets the sample rate for these cards and is required
in addition to the standard control register. It corresponds to a
quartz divisor.
Signed-off-by: Remy Bruno <remy.bruno@trinnov.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Changes from Realtek driver:
- New models hippo and hippo_1 for ALC262
- New models tagra-dig and tagra-2ch-dig for ALC883
- New id for ALC660 codec chip
Signed-off-by: Kailang Yang <kailang@realtek.com.tw>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch adds support for Toshiba laptops. Code is from
RealTek's alsa-driver-1.0.12-4.05b tree.
Signed-off-by: Tobin Davis <tdavis@dsl-only.net>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add support for AES32. Difference between MADI and AES32 is done
through revision. Master support is not finished for now (RME so-called DDS
feature is not supported yet)
Signed-off-by: Remy Bruno <remy.bruno@trinnov.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch adds audio support for Medion's line of laptops,
based on code shipped with the laptops. Microphone support is
still being explored.
Signed-off-by: Tobin Davis <tdavis@dsl-only.net>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Load the DSP and controller microcode using request_firmware(), if
possible, instead of using the built-in firmware.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Added the support for mixer matrix of RME9632 rev 152.
Signed-off-by: Remy Bruno <remy.bruno@trinnov.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Let the emu10k1 driver select FW_LOADER because the new Emu1010 support
requires it.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Let the AudioScience, Echoaudio and Riptide drivers select FW_LOADER
instead of depending on it so that they can be configured without having
to enable FW_LOADER manually.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Use pci_iomap and ioread*/iowrite*() functions for accessing
hardwares. pci_iomap is suitable for hardwares like ICH and
compatible that have both PIO and MMIO.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Enable the analog loopback of the Revolution 5.1 card.
This patch adds support for the PT2258 volume controller and modifies
the Revolution 5.1 driver to make use of this facility. This allows
to control the analog loopback of the card.
Signed-off-by: Jochen Voss <voss@seehuhn.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Enable capture from line-in and CD on the Revolution 5.1 card.
This patch adds support for switching between the 5 input channels of
the AK5365 ADC and modifies the Revolution 5.1 driver to make use of
this facility. Previously the capture channel was fixed to channel 0
(microphone on the Revolution 5.1 card).
Signed-off-by: Jochen Voss <voss@seehuhn.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Playing with spdif output on cmipci i've noticed the SPDO5V option does
not change appropriate bits the register.
The _snd_cmipci_uswitch_put checks the change in flags in wrong way.
If 'active' state of an option corresponds to a _zero_ bits in a hw
register then function fails. The SPDO5V is the sample.
In the most cases 'active' state of option is set through an non-zerio
bits in a register. This case works fine.
The fix attached.
Unfortunately i was unable to change spdif output voltage anyway.
Although the register changes right at least.
From: Timofei V. Bondarenko <tim@ipi.ac.ru>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch adds the Intel ICH9 HD Audio controller DID's for ALSA.
Signed-off-by: Jason Gaston <jason.d.gaston@intel.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fix races between the timer handler and the close function.
Signed-off-by: Giuliano Pochini <pochini@shiny.it>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add the support for HD audio controllers of MCP51,MCP55,MCP61,MCP65 & MCP67.
Signed-off-by: Peer Chen <pchen@nvidia.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
This patch fixes a couple of bit update functions in
alsa-kernel/pci/ac97/ac97_codec.c, which could possibly corrupt bits not
in the given mask.
Specifically, it'll clobber unset bits in the target that are not in the
mask, when the corresponding bit in the given new value is set.
Signed-off-by: James C Georgas <jgeorgas@rogers.com>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
I have ASUS P5PL2 motherboard and it's embedded sound card requires
the following patch which sets '3stack' model to operate properly:
00:1b.0 0403: 8086:27d8 (rev 01)
Subsystem: 1043:817f
Flags: bus master, fast devsel, latency 0, IRQ 177
Memory at dfdf8000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [50] Power Management version 2
Capabilities: [60] Message Signalled Interrupts: 64bit+
Queue=0/0 Enable-
Capabilities: [70] Express Unknown type IRQ 0
Signed-off-by: Nickolay V. Shmyrev <nshmyrev@yandex.ru>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fix IRQ flags for PCI devices.
The shared IRQs for PCI devices shouldn't be allocated with
IRQF_DISABLED. Also, when MSI is enabled, IRQF_SHARED shouldn't
be used.
The patch removes unnecessary cast in request_irq and free_irq,
too.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fix the type of PCI revision to char from int and avoid invalid
assignment with pointer cast.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
my notebook is a Samsung X11 of course... The attached patch fixes the typo.
Signed-off-by: Christian Hesse <mail@earthworm.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Fix the case cidx2 >= 0 and cidx2 < 0 which may result in negative
array index.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Make the output for PCM parameters more verbose, showing
each rate, bits and format.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Don't include 9.6kHz in the list of supported sample rates.
Since this rate isn't indicated in AC_PAR_PCM parameter,
the driver might guess wrongly as if it's available.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Add a proper model entry (laptop-eapd) for ASUS V1j laptop with
AD1986A codec.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
precise_ptr option causes dysfunction with hdsp driver.
Turn it off as default.
Signed-off-by: Remy Bruno <remy.bruno@trinnov.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
Some modem codec seem to fail in the initialization, and this
stopped loading of the whole module although the audio is OK.
Since it's usually a non-fatal issue, the driver tries to proceed
to initialize now.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Jaroslav Kysela <perex@suse.cz>
