tmp_suning_uos_patched/drivers/w1/masters/Kconfig
Madhusudhan Chikkature 9f2bc79f7d hdq driver for OMAP2430/3430
The HDQ/1-Wire module of TI OMAP2430/3430 platforms implement the hardware
protocol of the master functions of the Benchmark HDQ and the Dallas
Semiconductor 1-Wire protocols.  These protocols use a single wire for
communication between the master (HDQ/1-Wire controller) and the slave
(HDQ/1-Wire external compliant device).

This patch provides the HDQ driver to suppport TI OMAP2430/3430 platforms.

Signed-off-by: Madhusudhan Chikkature<madhu.cr@ti.com>
Acked-by: Felipe Balbi <felipe.balbi@nokia.com>
Acked-by: Evgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
2008-11-12 17:17:18 -08:00

64 lines
1.7 KiB
Plaintext

#
# 1-wire bus master configuration
#
menu "1-wire Bus Masters"
config W1_MASTER_MATROX
tristate "Matrox G400 transport layer for 1-wire"
depends on PCI
help
Say Y here if you want to communicate with your 1-wire devices
using Matrox's G400 GPIO pins.
This support is also available as a module. If so, the module
will be called matrox_w1.ko.
config W1_MASTER_DS2490
tristate "DS2490 USB <-> W1 transport layer for 1-wire"
depends on USB
help
Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
for example DS9490*.
This support is also available as a module. If so, the module
will be called ds2490.ko.
config W1_MASTER_DS2482
tristate "Maxim DS2482 I2C to 1-Wire bridge"
depends on I2C && EXPERIMENTAL
help
If you say yes here you get support for the Maxim DS2482
I2C to 1-Wire bridge.
This driver can also be built as a module. If so, the module
will be called ds2482.
config W1_MASTER_DS1WM
tristate "Maxim DS1WM 1-wire busmaster"
depends on W1 && ARM
help
Say Y here to enable the DS1WM 1-wire driver, such as that
in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
hx4700.
config W1_MASTER_GPIO
tristate "GPIO 1-wire busmaster"
depends on GENERIC_GPIO
help
Say Y here if you want to communicate with your 1-wire devices using
GPIO pins. This driver uses the GPIO API to control the wire.
This support is also available as a module. If so, the module
will be called w1-gpio.ko.
config HDQ_MASTER_OMAP
tristate "OMAP HDQ driver"
depends on ARCH_OMAP2430 || ARCH_OMAP34XX
help
Say Y here if you want support for the 1-wire or HDQ Interface
on an OMAP processor.
endmenu