fb286bb299
Here is the patch that introduces the generic skb_checksum_complete which also checks for hardware RX checksum faults. If that happens, it'll call netdev_rx_csum_fault which currently prints out a stack trace with the device name. In future it can turn off RX checksum. I've converted every spot under net/ that does RX checksum checks to use skb_checksum_complete or __skb_checksum_complete with the exceptions of: * Those places where checksums are done bit by bit. These will call netdev_rx_csum_fault directly. * The following have not been completely checked/converted: ipmr ip_vs netfilter dccp This patch is based on patches and suggestions from Stephen Hemminger and David S. Miller. Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au> Signed-off-by: David S. Miller <davem@davemloft.net> |
||
|---|---|---|
| .. | ||
| netfilter | ||
| addrconf.c | ||
| af_inet6.c | ||
| ah6.c | ||
| anycast.c | ||
| datagram.c | ||
| esp6.c | ||
| exthdrs_core.c | ||
| exthdrs.c | ||
| icmp.c | ||
| inet6_hashtables.c | ||
| ip6_fib.c | ||
| ip6_flowlabel.c | ||
| ip6_input.c | ||
| ip6_output.c | ||
| ip6_tunnel.c | ||
| ipcomp6.c | ||
| ipv6_sockglue.c | ||
| ipv6_syms.c | ||
| Kconfig | ||
| Makefile | ||
| mcast.c | ||
| ndisc.c | ||
| netfilter.c | ||
| proc.c | ||
| protocol.c | ||
| raw.c | ||
| reassembly.c | ||
| route.c | ||
| sit.c | ||
| sysctl_net_ipv6.c | ||
| tcp_ipv6.c | ||
| udp.c | ||
| xfrm6_input.c | ||
| xfrm6_output.c | ||
| xfrm6_policy.c | ||
| xfrm6_state.c | ||
| xfrm6_tunnel.c | ||